Copio y pego lo que puse en otro hilo.
Exacto. Si no alternara entre esos dos modos, ya no sería el modo EMTB que tan bien va y mucha gente no utiliza el turbo porque en zonas técnicas sobre todo,va mejor el EMTB.
Ojo,que esta actualización no es ninguna revolución,esa potencia solo la va a dar puntualmente,no se convertirá en el motor de la Haibike Flyon de repente.
Aquí lo explican muy bien:
Can you feel the extra 10 Nm of the Bosch software update?
If you’re hoping to use the update to make your current motor a lot stronger, you’ll be disappointed. While the update increases the torque of the Bosch Performance Line CX by 10 Nm, in most riding scenarios you won’t even notice the difference, because both the maximum support of 340% and the peak power output remain unchanged. On the trail, you won’t notice the additional torque even when riding in the Turbo mode at higher cadences, because the motor reaches its maximum power at a lower torque. You’ll only notice the difference between the “old” and “new” software when pedalling at lower cadences, approximately below 70 rpm. On the trail this offers real advantages, especially on short climbs and when accelerating out of corners. Here the updated motor accelerates more willingly and responds more dynamically, even if you’re riding in the wrong gear at a low cadence.
https://ebike-mtb.com/en/bosch-performance-line-cx-2020-software-update-review/Enviado desde mi iPad utilizando Tapatalk
